USD Series
Sand & Dust Chambers
USD-Series Sand & Dust chambers provide an environment to test the exposure of automotive and electronic components to concentrated levels of dust in order to validate product seal integrity.
Pulses of compressed air are blown through a manifold located in the
bottom of a collection trough, forcing dust up and over the product. Air
pulses are time-programmed for “on” and “off”
cycles. Concentration of dust can be easily varied by changing the air
pressure and the amount of the blowing time. All dust chambers are designed
to meet common test methods such as SAE
J575, subparagraph “G”, J.I.S. D-0207-1977, and
ASTM C-150-77. Approved dust types are Arizona Dust, Portland Cement
Dust, and 213 Silica Sand.
Power Requirements: 120/1/60
Standard Features
- Two Digital Timers
- Coalescing & Particulate Filters
- Exhaust with Cleanable Filter
- 16 Gauge Stainless Steel Interior
- Full-Opening Front Loading Door
- 3” Thick Foam Insulation
- Casters
Optional Accessories
- Access Ports
- Viewing Window
- Shelving
- Test Fixture Support Rails
- Self-Contained Air Compressor
- Interior Light with Switch
Workspace Volume |
10 cu. ft. (282L) |
27 cu. ft. (762L) |
|
|
|
|
Workspace Dimensions
|
24” H x 30”
W x 24” D |
36”
H x 36” W x 36” D |
|
(61cm x 76cm x 61cm)
|
(91cm x
91cm x 91cm) |
|
|
|
|
Exterior Dimensions
|
60” H x 55”
W x 35” D |
72”
H x 61” W x 45” D |
|
(152cm x 140cm x 89cm)
|
(183cm x
155cm x 114cm) |
|
